您的位置: 专家智库 > >

赵凯

作品数:2 被引量:3H指数:1
供职机构:北京航空航天大学机械工程及自动化学院更多>>
发文基金:国家自然科学基金更多>>
相关领域:金属学及工艺一般工业技术更多>>

文献类型

  • 1篇期刊文章
  • 1篇会议论文

领域

  • 2篇金属学及工艺
  • 1篇一般工业技术

主题

  • 1篇优化设计
  • 1篇静刚度
  • 1篇静刚度分析
  • 1篇机床
  • 1篇刚度分析
  • 1篇OPTIMI...
  • 1篇TI-6AL...
  • 1篇TI-6AL...
  • 1篇H-
  • 1篇HOT
  • 1篇SPRING...

机构

  • 2篇北京航空航天...
  • 1篇北京印刷学院

作者

  • 2篇李小强
  • 2篇李东升
  • 2篇赵凯
  • 1篇续明进
  • 1篇肖军杰
  • 1篇丁盼

传媒

  • 1篇Transa...
  • 1篇第十二届全国...

年份

  • 1篇2015
  • 1篇2014
2 条 记 录,以下是 1-2
排序方式:
数控拉弯机转臂静刚度优化设计
以数控拉弯机转臂为研究对象,采用workbench有限元软件转臂进行了静刚度分析,并对转臂不同位置的壁厚进行了优化设计,结果表明转臂内侧板壁厚是影响转臂静刚度的主要因素.优化结果为,内侧板厚增加10mm,外侧板厚增加5m...
赵凯李东升李小强
关键词:静刚度分析优化设计
文献传递
Process parameters optimization of Ti-6Al-4V alloy sheet during hot stretch-creep forming被引量:3
2015年
Hot stretch-creep forming (SCF) is a novel technique to produce hard-to-form thin-walled metal components. Comprehensively considering the analysis results of the springback angle, yield strength and microstructure, four hot SCF process parameters including temperature, stretch velocity, post stretch percentage and dwelling time of a Ti-6Al-4V alloy sheet were optimized using an orthogonal experiment. The results reveal that temperature is the most important factor on springback angle. The yield strength of the deformed material in 0° direction increases, while those in directions of 45° and 90° fluctuate around the original value. After hot SCF, the shape of some a phases changes from short thin grains to long slender ones, and the microhardness changes very little. The optimized parameters with temperature of 700 ℃, stretch velocity of 5 mm/min, post stretch percentage of 2% and dwelling time of 8 min are achieved finally.
肖军杰李东升李小强丁盼赵凯黄烜昭续明进
关键词:SPRINGBACKOPTIMIZATION
共1页<1>
聚类工具0