您的位置: 专家智库 > >

丁盼

作品数:2 被引量:3H指数:1
供职机构:北京航空航天大学机械工程及自动化学院更多>>
发文基金:国家自然科学基金更多>>
相关领域:一般工业技术金属学及工艺航空宇航科学技术更多>>

文献类型

  • 1篇期刊文章
  • 1篇会议论文

领域

  • 2篇一般工业技术
  • 1篇金属学及工艺
  • 1篇航空宇航科学...

主题

  • 1篇型材
  • 1篇铝合金型材
  • 1篇拉弯
  • 1篇回弹
  • 1篇航空工程
  • 1篇合金型材
  • 1篇OPTIMI...
  • 1篇TI-6AL...
  • 1篇TI-6AL...
  • 1篇H-
  • 1篇HOT
  • 1篇SPRING...

机构

  • 2篇北京航空航天...
  • 1篇北京印刷学院

作者

  • 2篇李小强
  • 2篇李东升
  • 2篇丁盼
  • 1篇续明进
  • 1篇肖军杰
  • 1篇金朝海
  • 1篇赵凯
  • 1篇刘志军

传媒

  • 1篇Transa...
  • 1篇第十二届全国...

年份

  • 1篇2015
  • 1篇2014
2 条 记 录,以下是 1-2
排序方式:
铝合金型材拉弯回弹波动影响研究
铝合金型材由于轻量化在航空工业中应用广泛,然而为了适应精密装配的需要,必须严格控制型材拉弯成形精度.本文通过现场调研分析了三个批次型材厚度、截面内角角度及材料性能的波动,并采用主成分分析法和多元回归分析发现材料性能波动对...
丁盼李小强李东升刘志军金朝海
关键词:航空工程铝合金型材
文献传递
Process parameters optimization of Ti-6Al-4V alloy sheet during hot stretch-creep forming被引量:3
2015年
Hot stretch-creep forming (SCF) is a novel technique to produce hard-to-form thin-walled metal components. Comprehensively considering the analysis results of the springback angle, yield strength and microstructure, four hot SCF process parameters including temperature, stretch velocity, post stretch percentage and dwelling time of a Ti-6Al-4V alloy sheet were optimized using an orthogonal experiment. The results reveal that temperature is the most important factor on springback angle. The yield strength of the deformed material in 0° direction increases, while those in directions of 45° and 90° fluctuate around the original value. After hot SCF, the shape of some a phases changes from short thin grains to long slender ones, and the microhardness changes very little. The optimized parameters with temperature of 700 ℃, stretch velocity of 5 mm/min, post stretch percentage of 2% and dwelling time of 8 min are achieved finally.
肖军杰李东升李小强丁盼赵凯黄烜昭续明进
关键词:SPRINGBACKOPTIMIZATION
共1页<1>
聚类工具0