您的位置: 专家智库 > >

王林军

作品数:4 被引量:5H指数:2
供职机构:沈阳化工大学更多>>
发文基金:辽宁省高等学校优秀人才支持计划更多>>
相关领域:理学一般工业技术电气工程更多>>

文献类型

  • 2篇期刊文章
  • 1篇学位论文
  • 1篇专利

领域

  • 2篇理学
  • 1篇电气工程
  • 1篇一般工业技术

主题

  • 1篇电池
  • 1篇性能研究
  • 1篇氧化钛
  • 1篇液相沉淀法
  • 1篇乙烷
  • 1篇溶胶
  • 1篇溶胶-凝胶法
  • 1篇三嵌段
  • 1篇三嵌段共聚物
  • 1篇嵌段
  • 1篇嵌段共聚
  • 1篇嵌段共聚物
  • 1篇锂硫电池
  • 1篇锰酸钾
  • 1篇介孔
  • 1篇介孔二氧化钛
  • 1篇聚环氧丙烷
  • 1篇聚环氧乙烷
  • 1篇环氧
  • 1篇环氧丙烷

机构

  • 4篇沈阳化工大学

作者

  • 4篇王林军
  • 3篇石中亮
  • 2篇姚淑华
  • 1篇王建枫
  • 1篇郭满

传媒

  • 1篇Chines...
  • 1篇化学研究与应...

年份

  • 1篇2023
  • 1篇2017
  • 2篇2016
4 条 记 录,以下是 1-4
排序方式:
硅、锌共掺杂介孔二氧化钛光催化剂的制备及应用性能研究被引量:3
2016年
采用溶胶-凝胶法,以四氯化钛、无水乙醇、冰乙酸、正硅酸四乙酯及醋酸锌为原料制备硅、锌共掺杂二氧化钛凝胶,凝胶经烘干、450℃焙烧2h得Si、Zn共掺杂介孔TiO_2光催化剂。对所制得的样品采用XRD、BET、SEM等测试手段进行表征,结果表明,样品为锐钛矿相,未掺杂时材料比表面积为90.9 m^2·g^(-1),掺杂Si、Zn后材料比表面积为219 m^2·g^(-1),孔径分布均匀。考察了硅-锌掺杂量对样品性能的影响。利用正交试验设计方法研究硅、锌共掺杂介孔二氧化钛的最佳制备条件,确定组成为Zn_(0.1)Si_(1.0)/TiO_2时,掺杂介孔二氧化钛光催化剂可见光下对亚甲基蓝的降解率最好,达到90.8%。
王建枫王林军石中亮
关键词:溶胶-凝胶法共掺杂介孔二氧化钛
基于固固转化机理的锂硫电池关键材料设计及性能研究
王林军
一种SBA‑15负载二氧化锰的制备方法
一种SBA‑15负载二氧化锰的制备方法,涉及一种无机材料制备方法,用分析天平称取 P123(聚环氧乙烷‑聚环氧丙烷‑聚环氧乙烷三嵌段共聚物)溶解到HCl溶液中,量取原硅酸四乙酯加入到上述溶液中,将所得固体在室温下过滤、水...
石中亮王林军姚淑华
文献传递
Preparation, Characterization and Photocatalytic Activity of Fe, La Co-doped Nanometer Titanium Dioxide Photocatalysts被引量:2
2016年
A series of photocatalysts of un-doped, single-doped and co-doped nanometer titanium diox- ide (TiO2) have been successfully prepared by template method using Fe(NO3)3.9H2O, La(NO3)3.6H2O, and tetrabutyl titanate as precursors and glucan as template. Scanning electron microscopy, X-ray diffraction, and N2 adsorption-desorption measurement were employed to characterize the morphology, crystal structure and surface structure of the samples. The photo-absorbance of the obtained catalysts was measured by UV-Vis absorption spectroscopy, and the photocatalytic activities of the prepared samples under UV and visible light were estimated by measuring the degradation rate of methyl orange in an aqueous solution. The characterizations indicated that the prepared photocatalysts consisted of anatase phase and possessed high surface area of ca. 163-176 m2/g. It was shown that the Fe and La co-doped nano-TiO2 could be activated by visible light and could thus be used as an effective catalyst in photo-oxidation reactions. The synergistic effect of Fe and La co-doping played an important role in improving the photocatalytic activity. In addition, the possibility of cyclic usage of co-doped nano-TiO2 was also confirmed, the photocatalytic activity of codoped nano-TiO2 remained above 89.6% of the fresh sample after being used four times.
石中亮郭满王林军姚淑华
共1页<1>
聚类工具0