The continuous separation of inclusions from aluminum melt flowing in a circular pipe using a high frequency magnetic field was investigated both theoretically and experimentally. The separation efficiency was calculated based on the trajectory method and compared with experimental results. It is found that the separation efficiency is a function ofnondimensional parameters ti . The effective way to improve the separation efficiency is to increase the effective magnetic flux density and decrease the pipe radius, and the value of should be kept about 2 in order to obtain the optimum separation efficiency.
Da SHU, Baode SUN, Ke LI, Jun WANG Yaohe ZHOUState Key Laboratory of Metal Matrix Composites, Shanghai Jiao Tong University, Shanghai 200030, China
Physical simulation is used to study the movement of nonmetallic particles in Al melt in electro- magnetic field. It is found that the terminal velocity of particles in different Reynolds number range has different functions. By confirming drag force coefficient of nonmetallic particles with Reynolds number in the range of 0.2-10 and 10-25 respectively, two functions of terminal ve- locity for spherical nonmetallic particles have been got accordingly, which provide a theoretical basis for separating nonmetallic inclusions from Al melt in electromagnetic field.
Tianxiao LI, Zhenming XU,Baode SUN,Da SHU and Yaohe ZHOU School of Materials Science and Engineering, Shanghai Jiaotong University, Shanghai 200030, China
Magnetohydrodynamic flow around the nonmetallic inclusions in aluminum melt and the force exerted on the inclusions were explored by dimensional analysis and numerical calculations. Dimensional analysis shows that the invariant characterizes the force exerted on the inclusions and the flow intensity of the melt. The physical significance of A is represented as a modified particle Reynolds number that reflects the effects of electromagnetic force. The fluid flow around the particle becomes unstable when A＞2×103. It is shown that the neglect of the inertial terms has little effect on the force exerted on the inclusions in the range of A≤1×106. However, the analytical solution of the maximum velocity inside the melt does not apply due to the appearance of turbulent flow in the case of A＞2×103.
Electromagnetic separation of non-metallic inclusions from Al-Si melt is studied by theoretical analysis and experiments on self-designed electromagnetic separation apparatus. Metallographs and LECO Image Analysis System were used to analyze the content of alumina in aluminum alloy before and after electromagnetic separation. It is seen that removal effciency increases with the increase of electromagnetic force (EMF) and diameter of inclusion particles while decreases with the increase of melt velocity and height of separator. All alumina particles with diamete of 14μm have been removed successfully from the melt.
Cylinder-like in-situ AI/24Si FGMs were produced by using electromagnetic separating process. Si primary phase reinforced layer with volume fraction as high as 16 pct was formed at the outer region of the cylinder-like samples where the local hardness and wear resistance were enhanced remarkably. Moreover, both of strength and ductility in the inner region provided insurance of reliable strength for this as-cast gradient material. It indicated that general mechanical properties such as good wear resistance at the outer region and good ductility in the central part could be obtained with the optimized redistribution of the Si primary particles under the electromagnetic force.
