We recently set up a time-resolved optical beam diagnostic system. Using this system,we measured the high current electron beam energy in the accelerator under construction. This paper introduces the principle of the diagnostic system,describes the setup,and shows the results. A bending beam line was designed using an existing magnetic analyzer with a 300 mm-bending radius and a 60° bending angle at hard-edge approximation. Calculations show that the magnitude of the beam energy is about 18 MeV,and the energy spread is within 2%. Our results agree well with the initial estimates deduced from the diode voltage approach.
One kind of instantaneous electron beam emittance measurement system based on the optical transition radiation principle and double imaging optical method has been set up.It is mainly adopted in the test for the intense electron-beam produced by a linear induction accelerator.The system features two characteristics.The first one concerns the system synchronization signal triggered by the following edge of the main output waveform from a Blumlein switch.The synchronous precision of about 1 ns between the electron beam and the image capture time can be reached in this way so that the electron beam emittance at the desired time point can be obtained.The other advantage of the system is the ability to obtain the beam spot and beam divergence in one measurement so that the calculated result is the true beam emittance at that time,which can explain the electron beam condition.It provides to be a powerful beam diagnostic method for a 2.5 kA,18.5 MeV,90 ns(FWHM)electron beam pulse produced by Dragon I.The ability of the instantaneous measurement is about 3 ns and it can measure the beam emittance at any time point during one beam pulse.A series of beam emittances have been obtained for Dragon I.The typical beam spot is 9.0 mm(FWHM)in diameter and the corresponding beam divergence is about 10.5 mrad.
