Impurity transports in two neighboring discharges with and without electron cyclotron resonance heating（ECRH）are studied in the HL-2A tokamak by laser blow-off（LBO） technique.The progression of aluminium ions as the trace impurity is monitored by soft x-ray（SXR） and bolometer detector arrays with good temporal and spatial resolutions.Obvious difference in the time trace of the signal between the Ohmic and ECRH L-mode discharges is observed.Based on the numerical simulation with one-dimensional（1D） impurity transport code STRAHL,the radial profiles of impurity diffusion coefficient D and convective velocity V are obtained for each shot.The result shows that the diffusion coefficient D significantly increases throughout the plasma minor radius for the ECRH case with respect to the Ohmic case,and that the convection velocity V changes from negative（inward） for the Ohmic case to partially positive（outward） for the ECRH case.The result on HL-2A confirms the pump out effect of ECRH on impurity profile as reported on various other devices.
An infrared imaging bolometer diagnostic has been upgraded recently to be adapted for the complications of the signal-to-noise ratio arising from the low level of plasma radiation and high reflectivity of low energy photon（〈6.2 eV）.It utilizes a platinum foil,blackened on both sides with graphite spray,as the bolometer detector.The advantage of the blackened foil is the light absorption extending into the infrared.After a careful calibration of the foil,the incident power density distribution on the foil is determined by solving the heat diffusion equation with a numerical technique.The local plasma radiated power density is reconstructed with a minimum fisher information regularization method by assuming plasma emission toroidal symmetry.Comparisons of the results and the profiles measured by an ordinary bolometric detector demonstrate that this method is good enough to provide the plasma radiated power pattern.The typical plasma radiated power density distribution before and after high mode（H-mode） transition is firstly reconstructed with the infrared imaging bolometer.Moreover,during supersonic molecular beam injection（SMBI）,an enhanced radiation region is observed at the edge of the plasma.
The ELMy H-mode plasmas realized with the supersonic molecular beam injection（SMBI） are studied in relation to the energy confinement and the heating power for the L–H transition（P_（L-H） ） in the HL-2A tokamak. A database is assembled for this study based on the ELMy H-mode discharges during the experimental campaigns in the period 2009–2013at the HL-2A tokamak. The statistical results show that the SMBI is favourable for reaching the H-mode by reducing the heating power at the L–H transition and for the H-mode performance by improving the energy confinement compared with the ordinary gas puffing（GP）. The reduction of P_（L-H） is about 20% when the density is low, and the energy confinement enhancement factor of H_（H98y2）= τ_E/τ_（th,98y2） ≈ 1.5 is achieved with the SMBI. Note that in the database the density dependence of P_（L-H） is non-monotonic with the ˉne,min≈ 3×10^（19） m^（-3） at which the P_（L-H） is minimum. Most of P_（L-H） data are on the low density branch where the P_（L-H） increases with the decrease in density. The minimum of the P_（L-H） in HL-2A is comparable to the ITPA multi-machine threshold power scaling P_（thr_scal08）. The physics behind the reduction of the P_（L-H） with the SMBI is also investigated in relation to the change of the density gradient at the plasma edge, the gas fuelling efficiency, and the recycling.
崔正英徐媛冯北滨许宇鸿丁玄同季小全李永高石中兵钟武律蒋敏宋绍栋程均高金明曹建勇董春凤张凯陈程远黄梅杨青巍段旭如hl-2a team
One of the critical issues to be solved for HL-2M is the power exhaust.Divertor target plate geometry strongly influences the plasma profiles by controlling the neutral recycling pattern,which in turn has a strong effect on the symmetry and stability of the divertor plasma and finally on the whole edge region.The numerical simulation SOLPS5.0 package is used to design and explore the divertor target plates for HL-2M.We start with the choice of a proper target plate geometry,which has a smaller incidence angle in the permissible space,and then discuss the method of gas puffing to reduce the heat flux density on the target and the effects of gas puffing on the divertor plasma performance.
In this paper, we describe the behavior of impurity transport in the HL-2A electron cyclotron resonance heating （ECRH） L-mode plasma. The neon as a trace impurity is injected by the supersonic molecular beam injection （SMBI） technique, which is used for the first time to study the impurity transport in HL-2A. The progression of neon ions is monitored by the soft X-ray camera and bolometer arrays with good temporal and spatial resolutions. The convection and diffusion process of the neon ions are investigated with the one-dimensional impurity transport code STRAHL. The results show that the diffusion coefficient D of neon ions is a factor of four larger than the neoclassical value in the central region. The value of D is larger in the outer region of the plasma （ρ 〉 0.6） than in the central region of the plasma （ρ 〈 0.6）. The convective velocity directs inwards with a value of ～-1.0 m/s in the Ohmic discharge, but it reverses to direct outwards with a value of ～ 8.0 m/s in the outer region of the plasma when ECRH is applied. The result indicates that the impurity transport is strongly enhanced with ECRH.
A normal incidence vacuum ultraviolet （VUV） and a grazing incidence extreme ultraviolet （EUV） spectrometers have been developed for the edge and core impurity measure- ments in HL-2A tokamak. The VUV and the EUV spectrometers cover wavelength ranges of 300-3200 A and 50-500A, respectively. A spatial resolution of 2 mm has been achieved for the VUV spectrometer when a space-resolved slit 50 #m in width is used. The space-resolved slit is placed between the entrance slit and the grating of the spectrometer. The spectral resolutions of 0.15/~ for the VUV spectrometer in the wavelength coverage of the concave 1200 grooves/mm grating and of 0.22A for the EUV spectrometer at λ=200A with a flat-field laminar-type holo- graphic grating are obtained. The sensitivity of the VUV spectrometer was calibrated in situ with the plasma bremsstrahlung radiation. The experimental results from both spectrometers are presented, especially the line intensity radial profiles measured by the VUV spectrometer.
One of the critical issues to be solved for HL-2M is the power and particle exhaust. Divertor target plate geometry strongly influences the plasma profiles by controlling the neutral recycling pattern, which has in turn a strong effect on the symmetry and stability of the divertor plasma and finally on the whole edge region. The numerical simulation software SOLPS5.0 Pack- age is used to design and explore the divertor target plates for HL-2M. We choose two divertor geometries, and assess the heat flux on the target plates and first wall, then further discuss the di- vertor plasma parameters, and how private flux baffling affects both neutral recirculation pattern and pumping efficiency.
