Turbulent flow and heat transfer coupled with solidification in slab continuous casting mold was studied by numerical simulation method. Volume of fluid （VOF） model is used to solve steel-air two-phase flow problem and enthalpy-porosity scheme is introduced to solve the fluid flow problem involving solidification. Contributions of various nozzle port angles and port widths and heights on the free surface fluctuation and the thickness of solidifying shell in slab mold were particularly investigated, based on which the structure of submerged entry nozzle was optimized. Flow inside the common nozzle port cannot fill the entire outlet area, having a recirculation in the upper portion of the port, which is enlarged for the nozzle port with both larger height and width. Results show that the flow in mold cavity is mainly controlled by the nozzle port angle. The increase of the angle of upper face of the port to shape a roughly streamlined inner-wall improves the effective area fraction of the nozzle, resulting in less jet impingement, weaker free surface turbulence and thicker solidifying steel shell.
The key to reduce shell breakout in the continuous casting process is to control shell thickness in the mold. A numerical simulation on the turbulent flow and heat transfer coupled with solidification in the slab mold using the volume of fluid （VOF） model and the enthalpy-porosity scheme was conducted and the emphasis was put upon the flow effect on the shell thickness profiles in longitudinal and transverse directions. The results show that the jet acts a stronger impingement on the shell of narrow face, which causes a zero-increase of shell thickness in a certain range near the impingement point. The thinnest shell on the slab cross-section locates primarily in the center of the narrow face, and secondly near the comer of the wide face. Nozzle optimization can obviously increase the shell thickness and make it more uniform.
