Carbon black supported ultra-high loading silver nanoparticle catalyst (Ag/CB) was prepared by a modified ethylene glycol reduction method, using ethylene glycol as the reducing agent and sodium hydroxide as the pH adjusting agent. The X-ray diffraction, thermogravimetry and scanning electron microscopy characterizations showed that the Ag nanoparticles crystallized with a face-centered cubic structure and were densely stacked on the CB surface without aggregation, despite such a small average size (ca. 10 nm) and an ultra-high loading mass (392 wt.%). The electrochemical evaluation based on cyclic voltammetry, chronoamperometry and polarization tests revealed that the ultra-high loading Ag/CB catalyst possessed a superior electrocatalytic activity for the oxidation of hydrazine, via a diffusion-limited process and a 4-electron transfer pathway. Moreover, the chronoamperometry response on an electrode modified with this ultra-high loading Ag/CB catalyst exhibited a promising application for determination of hydrazine, due to a broad linear calibration ranging from 50 to 800 μM, a high sensitivity of 0.03795 A/ M and a low detection limit of 3.47 μM.
TAN ChangXU XinHuaWANG FengLI ZhiLinLIU JingJunJI Jing
Non-enzymatic electrochemical sensors for the determination of hydrogen peroxide(H_(2)O_(2))have attracted more and more concerns.A series of nickel and cobalt double oxides(Ni_(x)Co_(y)-DO)with the different ratios of Ni/Co have been prepared by a polyol-mediated solvothermal method for H_(2)O_(2)detection.The obtained products exhibit honeycomb-like open porous microtubes constituted with the low-dimensional nanostructured Ni_(x)Co_(y)-DO blocks after the calcination treatment.Compared with nickel oxides,the introduced Co ions in Ni_(x)Co_(y)-DO can induce the production of surficial oxygen vacancies,and further enhance the electrode surface activity.In particular,the NiCo-DO sample(with an atomic ratio of Ni/Co=4:3)shows the richest surficial oxygen vacancies and presents the highest H_(2)O_(2)detection activity among all the as-prepared samples,demonstrating an excellent sensitivity of698.60μAL mmol^(-1)cm^(-2)(0~0.4 mmol/L),low detection limit(0.28μmol/L,S/N=3),as well as long stability,high selectivity and good reproducibility.This work lends a new impetus to the potential application of double metal oxides for the next generation of non-enzymatic sensors.
Pt/WO3/C nanocomposites with parallel WO3 nanorods were synthesized and applied as the cathode catalyst for proton exchange membrane fuel cells （PEMFCs）. Electrochemical results and single cell tests show that an enhanced activity for the oxygen reduction reaction （ORR） is obtained for the Pt/WO3/C catalyst compared with Pt/C. The higher catalytic activity might be ascribed to the improved Pt dispersion with smaller particle sizes. The Pt/WO3/C catalyst also exhibits a good electrochemical stability under potential cycling. Thus, the Pt/WO3/C catalyst can be used as a potential PEMFC cathode catalyst.
Meiling DouMing HouZhilin LiFeng WangDong LiangZhigang ShaoBaolian Yi
Poly（D,L-lactide-co-glycolide）（PLGA） microspheres were prepared by emulsion solvent evaporation method. The influences of inner aqueous phase, organic solvent, PLGA concentration on the morphology of microspheres were studied. The results showed that addition of porogen or surfactants to the inner aqueous phase, types of organic solvents and polymer concentration affected greatly the microsphere morphology. When dichloromethane was adopted as organic solvent, microspheres with porous structure were produced. When ethyl acetate served as organic solvent, two different morphologies were obtained. One was hollow microspheres with thin porous shell under a lower PLGA concentration, another was erythrocyte-like microspheres under a higher PLGA concentration. Three types of microspheres including porous, hollow core with thin porous shell（denoted by hollow in brief） and solid structures were finally selected for in vitro drug release tests. Bovine serum albumin（BSA） was chosen as model drug and encapsulated within the microspheres. The BSA encapsulation efficiency of porous, hollow and solid microspheres was respectively 90.4%, 79.8% and 0. And the ultimate accumulative release was respectively 74.5%, 58.9% and 0. The release rate of porous microspheres was much slower than that of hollow microspheres. The experiment results indicated that microspheres with different porous structures showed great potentials in controlling drug release behavior.
采用长链聚合物聚二烯丙基二甲基氯化铵(PDDA)对多壁碳纳米管(MWCNTs)进行修饰,并将采用胶体法还原出的铂(Pt)纳米粒子通过静电作用担载于PDDA修饰的多壁碳纳米管上,从而制备出Pt/PDDA/MWCNTs复合电催化剂.透射电镜(TEM)与X射线衍射(XRD)测试结果表明,Pt纳米粒子均匀地分布在MWCNTs的表面,其平均粒径约为3.6 nm.热失重分析显示催化剂的实际负载量为36%(w).旋转圆盘电极测试结果表明,Pt/PDDA/MWCNTs催化剂对碱性条件下的氧气还原反应(ORR)具有优异的催化活性.与负载量为40%(w)的商业Pt/C催化剂相比,Pt/PDDA/MWCNTs催化剂的氧气还原反应的起始电位和半波电位均正移约30 m V,其质量比活性更大.动力学研究结果进一步证实Pt/PDDA/MWCNTs催化剂比负载量为40%(w)的商业Pt/C催化剂在碱性条件下对氧气还原反应具有更优异的催化活性.
A highly porous nickel-film electrode with satisfactory mechanical strength was prepared by a facile vertical template-assisted composite electrodeposition method using polystyrene(PS) microspheres templates, with the aim of improving the electrocatalytic activity for the hydrogen-evolution reaction(HER). During the composite electrodeposition process, the hydrophobic PS microspheres were highly dispersed in the electrolyte with the help of a surfactant, and then co-deposited with Ni to form the film electrode. After removing the PS templates by annealing, a porous Ni film containing large amount of uniformly dispersed pores with narrow size distribution was obtained, and then applied as the electrode for the HER in an alkaline medium. As evidenced by the electrochemical analysis, the porous Ni film electrode exhibits higher catalytic activity as compared to a dense Ni film electrode and is superior to a Ni/Ru O2/Ce O2 commercial electrode. The effect of temperature on the catalytic properties of the porous Ni film electrode was also investigated; the activation energy was calculated as 17.26 k J/mol. The enhanced activity toward the HER was attributed to the improved electrochemical surface area and mass transportation facilitated by the high porosity of the synthesized Ni film electrode.
