Since the capacity of CO2 adsorption of coal is a key factor in coal and CO2 outbursts,an experimental study was carried out on CO2 isothermal adsorption with high-pressure volumetry with dry coal samples from the No.2 coal seam in the Haishiwan Coalfield.Four different equations(Langmuir,BET,D-R and D-A) were used to fit the experimental data.We discuss adsorption mechanisms.The results show that the amount of CO2 adsorption increases rapidly under low relative pressure,i.e.,the ratio of equilibrium pressure and saturated vapor pressure,which indicates that molecular layer adsorption or micropore filling may occur in coal.No clear equilibrium state was observed on the isothermal adsorption curves under relative pressure(P /P0 ) ranging from 0 to 0.8.The fitted results show that the accuracy of the D-A equation is highest with n=1.Micropores are more developed in coal by comparing the BET equation with a pressure mercury injection method on the surface area.The D-A equation(n=1) provides the best fit.By comparing the calculated specific surface area of the BET equation and the mercury intrusion method,it is found that micropore adsorption of CO2 occupies a dominant position.
For a study of the movement and deformation of coal-rock mass and low protected seams below a stope,as well as for fracture developments and rules of evolution of permeability,we designed a plane strain model test stand to carry out model tests of similar materials in order to improve the effect of gas drainage from low protected seams and to measure the movement and deformation of coal-rock mass using a method of non-contact close-range photogrammetry.Our results show that 1) using paraffin melting to take the place of coal seam mining can satisfy the mining conditions of a protective seam;2) coal-rock mass under goafs has an upward movement after the protective seam has been mined,causing floor heaving;3) low protected seams become swollen and deformed,providing a good pressure-relief effect and causing the coal-rock mass under both sides of coal pillars to become deformed by compression and 4) the evolution of permeability of low protected seams follows the way of initial values→a slight decrease→a great increase→stability→final decrease.Simultaneously,the coefficient of air permeability increased at a decreasing rate with an increase in interlayer spacing.
Based on theoretical analysis, similarity simulation tests, numerical simulation analysis and field observations, we analyzed rock collapse and rules of fraction evolution of overlying rocks and studied the rules in controlling the effect of an extremely thick igneous rock, found above a main mining coal seam in an area prone to coal mine disasters in the Haizi Coal Mine. The results show that this igneous rock, called a "main key stratum", will not subside nor break for a long time, causing lower fractures and bed separations not to close. The presence of igneous rock plays an important role in rock bursts, mine floods, gas outburst and surface subsidence in coal mines. By analyzing the rules in controlling the effect of this igneous rock, we provide useful references for safety and high efficiency mining in coal mines under special geological conditions.
In this study we measured the △P(initial speed of gas emission) index with different gas concentrations of carbon dioxide(pure CO2,90% CO2+10% CH4,67% CO2+33% CH4,50% CO2+50% CH4,30% CO2+10% CH4 and pure CH4) of coal samples from the No.2 coal seam in the Yaojie Coal Mine,Gansu province,China.The effect of carbon dioxide concentration,gas composition,coal strength and particle size of coal samples on the △P index was investigated.The experimental results show that with gas of various compositions,the △P value of three samples were clearly different.The △P index of coal samples A,B and C(0.2～0.25 mm) were 4,6 and 7 with pure CH4 and 22,30 and 21 when pure CH4 was used.Carbon dioxide concentration affects the △P index markedly.The △P index increases with an increase in carbon dioxide concentration,especially for coal B.Hence,the △P index and K(another outburst index) values tested only with pure CH4 for prediction of the danger of outburst is not accurate.It is important to determine the initial speed of gas emission given the gas composition of the coal seam to be tested for exact outburst prediction.
