A theoretical introduction of saturable absorber based on standing-wave saturation effects as a transient fiber Bragg grating （FBG） was presented. The central wavelength of the transient FBG was located in 2 μm. The factors affecting the bandwidth and the reflectivity of the transient FBG were analyzed. The linewidth and reflectiv- ity as the function of doped fiber length and doping concentration were correspondingly simulated by Matlab software. It was found that the larger the doping concentration and the fiber length were, the smaller the bandwidth was. These results suggest that the performance of the transient FBG can be optimized by choosing the appropriate length of doped fiber and the larger doping concentration, which can be used as a reference for the narrow-linewidth fiber laser around 2 μm.
We propose a side-core holey fiber （SCHF）-based surface plasmon resonance （SPR） sensor to achieve high refractive index （RI） sensitivity. The SCHF structure can facilitate analyte filling and enhance the overlapping area of the core mode and surface plasmon polariton （SPP） mode. The coupling properties of the sensor are analyzed by numerical simulation. The maximum sensitivity of 5000 nm/RIU in an RI range of 1.33-1.44, and the average sensitivity of 9295 nm/RIU in an RI range from 1.44 to 1.54 can be obtained.
A new in-line Mach-Zehnder interferometer （MZI） sensor consisting of a stub of multi-mode fiber and an up-taper was proposed and demonstrated. Temperature measurement can be carried out by detecting wavelength shift. Dependency of sensitivity on interferometer length and dip wavelength was discussed. Experimental results showed a maximum temperature sensitivity of 113.6pm/℃ can be achieved, which is superior to most fiber temperature sensors based on in-line MZIs within the range from 20℃ to 80℃, also a good mechanical strength can be obtained. The proposed sensor is a good candidate for temperature measurement, due to the advantages of simple structure, easy fabrication, cost- effective and high sensitivity.
The recent research progress in the key device and technology of the fiber optic sensor network （FOSN） is introduced in this paper. An architecture of the sensor optical passive network （SPON）, by employing hybrid wavelength division multiplexing/time division multiplexing （WDM/TDM） techniques similar to the fiber communication passive optical network （PON）, is proposed. The network topology scheme of a hybrid TDM/WDM/FDM （frequency division multiplexing） three-dimension fiber optic sensing system for achieving ultra-large capacity, long distance, and high resolution sensing performance is performed and analyzed. As the most important device of the FOSN, several kinds of light source are developed, including the wideband multi-wavelength fiber laser operating at C band, switchable and tunable 2 μm multi-wavelength fiber lasers, ultra-fast mode-locked fiber laser, as well as the optical wideband chaos source, which have very good application prospects in the FOSN. Meanwhile, intelligent management techniques for the FOSN including wideband spectrum demodulation of the sensing signals and real-time fault monitoring of fiber links are presented. Moreover, several typical applications of the FOSN are also discussed, such as the fiber optic gas sensing network, fiber optic acoustic sensing network, and strain/dynamic strain sensing network.
