It is desired to require a walking robot for the elderly and the disabled to have large capacity,high stiffness,stability,etc.However,the existing walking robots cannot achieve these requirements because of the weight-payload ratio and simple function.Therefore,Improvement of enhancing capacity and functions of the walking robot is an important research issue.According to walking requirements and combining modularization and reconfigurable ideas,a quadruped/biped reconfigurable walking robot with parallel leg mechanism is proposed.The proposed robot can be used for both a biped and a quadruped walking robot.The kinematics and performance analysis of a 3-UPU parallel mechanism which is the basic leg mechanism of a quadruped walking robot are conducted and the structural parameters are optimized.The results show that performance of the walking robot is optimal when the circumradius R,r of the upper and lower platform of leg mechanism are 161.7 mm,57.7 mm,respectively.Based on the optimal results,the kinematics and dynamics of the quadruped walking robot in the static walking mode are derived with the application of parallel mechanism and influence coefficient theory,and the optimal coordination distribution of the dynamic load for the quadruped walking robot with over-determinate inputs is analyzed,which solves dynamic load coupling caused by the branches' constraint of the robot in the walk process.Besides laying a theoretical foundation for development of the prototype,the kinematics and dynamics studies on the quadruped walking robot also boost the theoretical research of the quadruped walking and the practical applications of parallel mechanism.
WANG HongboSANG LingfengHU XingZHANG DianfanYU Hongnian
For the existing problems of walking chair robot such as simple function,lower bearing capacity and not walking in complex environment,a novel varistructured quadruped / biped human-carrying walking chair robot is proposed.The proposed robot could be used as biped and quadruped walking chair robots.Considering the conversion of the walking chair robot from the quadruped to the biped or vice versa,6-UPS and 2-UPS+UP(U,P and S are universal joint,the prismatic pair,and sphere joint,respectively) parallel mechanisms are selected as the leg mechanism of the biped walking robot and quadruped walking robot,respectively.Combining the screw theory and theory of mechanism,the degrees of freedom of the leg mechanism and the body mechanism in diferent motion states are computed so as to meet the requirements of mechanism design.The motion characteristics of the 2-UPS+UP parallel mechanism which is the key part of the walking chair robot are analyzed.Then,the workspace of the moving platform is drawn and the efect of the structural parameters on the workspace volume is studied.Finally,it is found that the volume of the workspace of the moving platform is bigger when the side length ratio and the vertex angle ratio of the fxed platform and the moving platform which are isosceles triangles are close to 1.This study provides a theoretical foundation for the prototype development.
