Four-wave mixing induced by modulation instability in a single-mode fiber is analyzed from the phase-matching point of view. For the two-channel transmission, a method is proposed to select the four-wave-mixing-induced sidebands, which is based on the proper use of a continuous-wave and a pulse as light sources. We find that a mass of sidebands are generated in the modulation instability resonance region, and the power of the sideband increases with not only the peak power of the pump pulse but also the continuous-wave power which acts as a seed. The research will provide guidance for fiber communication and sensing systems using wavelength division multiplexing technology.
Stimulated Brillouin scattering-induced phase noise is harmful to interferometric fiber sensing systems.The localized fluctuating model is used to study the intensity noise caused by the stimulated Brillouin scattering in a single-mode fiber.The phase noise structure is analyzed for an interferometric fiber sensing system,and an unbalanced Michelson interferometer with an optical path difference of 1 m,as well as the phase-generated carrier technique,is used to measure the phase noise.It is found that the phase noise is small when the input power is below the stimulated Brillouin scattering threshold,increases dramatically at first and then gradually becomes flat when the input power is above the threshold,which is similar to the variation in relative intensity noise.It can be inferred that the increase in phase noise is mainly due to the broadening of the laser linewidth caused by stimulated Brillouin scattering,which is verified through linewidth measurements in the absence and presence of the stimulated Brillouin scattering.
For distributed fiber Raman amplifiers(DFRAs), stimulated Brillouin scattering(SBS) can deplete the pump once occurring and consequently generate gain saturation. On the basis of such a theory, theoretical gain saturation powers in DFRAs with various pump schemes are obtained by calculating SBS thresholds in them, and the experimental results show that they are in excellent agreement with the calculation results. The saturation power of the DFRA with a 300 m W forward pump is as low as 0 d Bm, which needs to be enhanced by phase modulation, and the effect is quantitatively studied. A simple model taking both modulation frequency and index into consideration is presented by introducing a correction factor to evaluate the effect of phase modulation on the enhancement of saturation power. Experimentally, it is shown that such a correction factor decreases as the modulation frequency increases and approaches zero when the modulation frequency becomes high enough. In particular, a phase modulation with a modulation frequency of 100 MHz and a modulation index of 1.380 can enhance the saturation power by 4.44 d B, and the correction factor is 0.25 d B, in which the modulation frequency is high enough. Additionally, the factor is 1.767 d B for the modulation frequency of 25 MHz. On this basis,phase modulations with various indexes and a fixed frequency of 25 MHz are adopted to verify the modified model, and the results are positive. To obtain the highest gain saturation power, the model is referable. The research results provide a guide for the design of practical DFRAs.
The phase noises of two narrow-linewidth fiber laser and laser diode are measured by using unbalanced Michelson interferometers with various optical path differences (OPDs). The measured results indicate that the phase noises of the two lasers do not change linearly with the OPD over the range from 1 to 100 m. The laser diode exhibits phase noise levels higher than that of the fiber laser at OPDs longer than 10 m. However, the laser diode outperforms the fiber laser at OPDs shorter than 10 m. The results obtained can assess laser performance and determine the suitable laser for use in a particular application.
