A novel multiple super junction （MS J） LDMOS power device is proposed to decrease Ron due to lateral and vertical interactions between the N-pillar and P-pillar. In the studied device： multiple layers of SJ are introduced oppositely under surface S J; when compared with 2D-depleting of the conventional super junction （CSJ）, a 3D- depleted effect is formed in the MSJ thanks to vertical electric field modulation; and, current distribution is improved by deep drain, which increases the drift doping concentration and results in a lower on-resistance. The high electric field around the drain region by substrate-assisted depleted effect is reduced due to the charge balance result from the electric field shielding effect of the bottom S J, which causes the uniform electric field in the drift region and the high breakdown voltage. The numerical simulation results indicate that the specific on-resistance of the MSJ device is reduced by 42% compared with that of CSJ device, while maintaining a high breakdown voltage; the cell pitch of the device is 12 μm.
The impact of various thicknesses of Al2O3 metal-insulator-metal （MIM） capacitors on direct current and radio frequency （RF） characteristics is investigated. For 20 nm Al2O3, the fabricated capacitor exhibits a high capacitance density of 3850 pF/mm2 and acceptable voltage coefficients of capacitance of 681 ppm/V2 at 1 MHz. An outstanding VCC-a of 74 ppm/V2 at 1 MHz, resonance frequency of 8.2 GHz and Q factor of 41 at 2 GHz are obtained by 100 nm Al2O3 MIM capacitors. High-performance MIM capacitors using GaAs process and atomic layer deposition Al2O3 could be very promising candidates for GaAs RFIC applications.
A new high-voltage LDMOS with linearly-distanced fixed charge islands is proposed （LFI LDMOS）. A lot of linearly-distanced fixed charge islands are introduced by implanting the Cs or I ion into the buried oxide layer and dynamic holes are attracted and accumulated, which is crucial to enhance the electric field of the buried oxide and the vertical breakdown voltage. The surface electric field is improved by increasing the distance between two adjacent fixed charge islands from source to drain, which lead to the higher concentration of the drift region and a lower on-resistance. The numerical results indicate that the breakdown voltage of 500 V with Ld = 45μm is obtained in the proposed device in comparison to 209 V of conventional LDMOS, while maintaining low on- resistance.
A new high-voltage LDMOS with folded drift region （FDR LDMOS） is proposed. The drift region is folded by introducing the interdigital oxide layer in the： Si active layer, the result of which is that the effective length of the drift region is increased significantly. The breakdown characteristic has been improved by the shielding effect of the electric field from the holes accumulated in the surface of the device and the buried oxide layer. The numerical results indicate that the breakdown voltage of 700 V is obtained in the proposed device in comparison to 300 V of conventional LDMOS, while maintaining low on-resistance.
A novel radio frequency （RF） switch device has been successfully fabricated using InGaAs metal- oxide-semiconductor field-effect transistor （MOSFET） technology. The device showed drain saturation currents of 250 mA/mm, a maximum transconductance of 370 mS/ram, a turn-on resistance of 0.72 mx2.mm2 and a drain current on-off （Ionloll） ratio of 1 x 106. The maximum handling power of on-state of 533 mW/mm and off-state of 3667 mW/mm is obtained. The proposed In0.4Ga0.6As MOSFET RF switch showed an insertion loss of less than 1.8 dB and an isolation of better than 20 dB in the frequency range from 0.1 to 7.5 GHz. The lowest insertion loss and the highest isolation can reach 0.27 dB and more than 68 dB respectively. This study demonstrates that the InGaAs MOSFET technology has a great potential for RF switch application.
