Well-aligned TiO2 nanorod arrays (TNAs) were prepared on pretreated quartz substrates via hydrothermal method.The effect of the different preparation conditions on the growth morphologies of TNAs was systematically investigated by X-ray diffraction (XRD) and field-emission scanning electron microscopy (FE-SEM).The photocatalytic properties were tested by photodegradation of a methyl blue solution.It is demonstrated that the hydrothermal reaction conditions,such as precursor concentration,hydrothermal reaction temperature,and hydrothermal reaction times,can greatly affect the growth of TNAs.Controlling the preparation process,TNAs with 2 μm in length and 140-170 nm in diameter and well-aligned orientation have been successfully prepared.The photocatalytic experiment results indicate that TNAs have much better photocatalytic activity than TiO2 nanoparticles.
Nano TiO2/Fe3O4 composite particles with different molar ratios of TiO2 to Fe3O4 were prepared via sol-gel method. X-ray diffraction, transmission electron microscopy, and vibration sample magnetometry were used to characterize the TiO2/Fe3O4 particles. The photocatalytic activity of the particles was tested by degrading methyl blue solution under UV illumination (254 nm). The results indicate that with the content of TiO2 increasing, the photocatalytic activity of the composite particles enhances, while the magnetism of the particles decreases. When the molar ratio of TiO2 to Fe3O4 is about 8, both the photocatalytic activity and magnetism of the TiO2/Fe3O4 particles are relatively high, and their photocatalytic activity remains well after repeated use.
The Gibbs free energies of reaction △ r GTof KNbO3 and NaNbO3 were calculated and then that of KxNa1-xNbO3 was estimated. On the ba-sis of the thermodynamic calculation results, the hydrothermal temperatures were designed at 100, 160, and 230°C respectively. However, NaNbO3 was prepared when the heating temperature was higher than 160°C, and KNbO3 and KxNa1-xNbO3 were obtained at 230°C, sug-gesting that only at a higher temperature the kinetic requirement is satisfied. According to the X-ray diffraction results, both the solid solu-tions, NaNbO3-based solid solution, Na1-xKxNbO3, and KNbO3-based solid solution, K1-xNaxNbO3, were hydrothermally synthesized in 6 mol/L alkali (NaOH and KOH) solution at 230°C.
