The morphology,microstructure and decomposition behavior of M_2C carbides in high speed steels with different chemical compositions have been investigated by scanning electron microscopy,transmission electron microscopy,electron backscatter diffraction and X-ray diffraction.The results show that the morphology and substructure of M_2C carbides are very sensitive to chemical compositions of high speed steels.M_2C carbides present the plate-like shape in tungsten-molybdenum steel and present the polycrystal orientation in the eutectic cell.In contrast,they show the fibrous shape in molybdenum-base steel and exhibit the monocrystal orientation.Plate-like and fibrous M_2C carbides are both metastable and decompose into M6 C together with MC at high temperatures.MC nucleates inside the plate-like M_2C while it is formed at the fibrous M2C/matrix interface during the decomposition process.Such differences are expected to arise from different compositions of plate-like and fibrous M_2C carbides.
Low carbon steel wires were prepared by two processes,serial drawing(SD)and reverse-direction drawing(RD).Effects of the two processes on microstructure and mechanical properties in steel wires were investigated by field emissio scanning electron microscopy,electron backscatter diffraction(EBSD),X-ray diffraction and transmission electron microscopy(TEM).Residual compressive stress and more low-angle grain boundaries were introduced into the steel wire by the RD.As a result,the RD wires exhibited a greater tensile strength when drawing strain s<1.18.The SD encouraged grain refinement and texture formation in the wire.The SD wires exhibited a smaller average width of the elongated ferrite grain and a higher intensity of(110)fiber texture at all drawing strains.Therefore,the SD wires showed a bit greater tensile strength and 20%greater torsion performance than the RD wires at c=2.51.TEM and EBSD analysis indicated that dislocation tangle was formed easily in RD wires,and it transformed into twist boundary.This twist boundary impeded the grain refinement in the RD wires,and there were still non-fibrous grains in the RD wires even after heavy drawing.
